DRIVER RESTRAINT SYSTEMS
All harness sections must be mounted to the frame, crossmember, or reinforced mounting, and installed to limit driver’s body travel both upward and forward. Seat belts may not be wrapped around lower frame rails. All seat belts and shoulder harness installations must be mutually compatible, originally designed to be used with each other. For harness installation see Illustration. Only those units that release all five attach points in one motion are accepted. Under no circumstances are bolts inserted through bell webbing acceptable for mounting. Check manufacturer’s instructions.
HEAD PROTECTOR
In any car where a roll bar is installed, a padded head protector must be provided at the back of the driver’s head and constructed in an attempt to prevent whiplash upon impact. The roll bar or cage must be padded wherever it may come in contact with the driver's helmet: Adequate-padding should permit approximately 1/4-inch compression. The use of weather stripping and similar thin or low impact resisting materials is prohibited. A padded roll bar or cage alone is not acceptable as a padded head protector unless it is within 4-inches of the driver's helmet. A seat that incorporates a reinforced head rest is acceptable.
BATTERY & BATTERY BOX MOUNTING