FUEL
1. FUEL CELL ARE REQUIRED, MAXIMUM 32 GALLON, MUST BE SECURELY FASTENED IN TRUNK AND MUST HAVE A SEALED FIRE WALL BETWEEN DRIVER AND FUEL CELL.
2. BOTTOM OF FUEL CELL MUST BE MOUNTED ABOVE CENTER LINE OF REAR END HOUSING.
3. MINIMUM 20 GAUGE STEEL CASE SURROUNDING FUEL CELL REQUIRED.
4. FUEL CELL MUST HAVE TWO 1/8" X 2" WIDE STEEL STRAPS SURROUNDING THE FUEL CELL FOR MOUNTING. (SEE DRAWING.)
5. GRADE #5 BOLTS ARE REQUIRED FOR MOUNTING FUEL CELL.
6. NO FUEL LINES ARE PERMITTED TO RUN THROUGH THE INTERIOR.
7. RACING TYPE BRAIDED FUEL LINES ARE HIGHLY RECOMMENDED.
8. NO ELECTRICAL FUEL PUMPS.
9. ALCOHOL (METHANOL) IS ALLOWED.
10. ALCOHOL UPPER END LUBE ALLOWED.
11. RACING GASOLINE ALLOWED.
12. NO NITROUS OXIDE.
13. NO NITROMETHANE.
14. NO FUEL INJECTION.
15. NO PROPOLENE OXIDE.
TIRES AND WHEELS
1. MAXIMUM 10" WIDE STEEL WHEELS ONLY.
2. 2 BEAD LOCKS ALLOWED.
3. ALUMINUM BOLT PATTERN ADAPTER ALLOWED MAX ONE INCH WIDE.
4. ALUMINUM OR STEEL WHEEL SPACERS ALLOWED MUST SLIDE OVER STUDS.
5. MAXIMUM TIRE TREAD WIDTH IS 10". (FOOT PRINT MEASURED FROM OUTSIDE EDGE TO OUTSIDE EDGE.)
6. NO SHAVING EDGES OF TIRES TO OBTAIN 10" TREAD WIDTH.
7. NO ALUMINUM WHEELS.
8. WHEEL STUDS MUST BE TORQUED TO 80 LBS. MINIMUM.
9. MINIMUM ½” WHEEL STUDS AND 1" LUG NUT MANDATORY. (SEE DRAWING) 5/8 STUDS RECOMMENDED.
10. EACH WHEEL MUST HAVE 5 WHEEL STUDS AND NUTS.
DRIVER/INTERIOR
I. FIRE SUITS ARE MANDATORY, MUST FIT DRIVER AND BE IN VERY GOOD CONDITION (SUBJECT TO INSPECTION.)
2. FIRE SUITS MUST BE WORN DURING PARTICIPATION. PANTS AND JACKETS OR ONE PIECE SUIT.
3. HELMET, FULL FACE HELMET REQUIRED.
4. HELMET MUST MEET OR EXCEED SNELL 1995 REQUIRMENTS.
5. FIRE PROTECTION RACING GLOVES AND SHOES ARE RECOMMENDED.
6. KILL SWITCH MUST BE IN EASY REACH OF DRIVER AND SAFETY CREW MUST BE CLEARLY MARKED "ON"AND "OFF" AND MUST KILL ENGINE.
7. WINDOW NET ON DRIVER'S SIDE OR ARM RESTRAINTS ARE RECOMMENDED.
DRIVER SEAT
I. ALUMINUM RACING SEAT IS REQUIRED.
2. SEAT MUST BE BOLTED DOWN WITH GRADE #5 BOLTS AND MOUNTED AT BOTTOM AND BACK. (SEE DRAWING).
3. NO FIBERGLASS OR POLY SEATS ALLOWED.
SEAT BELTS
1. 5 POINT, 3" WIDE RACING SEAT HARNESS ARE REQUIRED. (MUST USE CROTCH STRAP)
2. SEAT BELTS MUST BE MOUNTED TO FRAME BY USING GRADE #5 BOLTS AT ALL 5 POINTS. (SEE DRAWING)
3. SEAT BELTS MUST NOT BE ANY OLDER THAN TWO (2) YEARS OLD AND MUST BE IN EXCELLENT CONDITION.